When placing Segmented Registration Marks (horizontal) in Illustrator version after CC2018, the middle mark might be displayed as figure on the right. (*3) The firmware needs to be the follwong version.
* It cannot be used on the port created by other drivers (e.g. (2) When using LAN (network) connection: "Add device settings" > "TCP / IP" (1) When using USB connection: "Add device settings" > "Graphtec USB"
* In case of using Data Link in Cutting Master 4/Graphtec Pro Studio, select and use the following two patterns depending on the connection method. * Administrator permission will be required. The Cutting Master 3 / Graphtec Studio needs to be closed before the Cutting Master 4 is started.
* The Cutting Master 4 and the Cutting Master 3 / Graphtec Studio cannot be used simultaneously. Note: Please use Ver.2.10 to operate CE5000. Note: Please use Ver.2.20 to operate FC8000. Note: Please use Ver.3.20 when using Cutting Master 4 on Windows 7. I'll come back and post a reply, once I can confirm version PSP X will also work with Windows 10.Downloading Files Ver.3.90 (Latest version)
I am so happy to know I might be able to install and use PSP X.
One of the main reasons I've held off moving to windows 10 is because I've feared losing the use of favorite software. HTHBree, 'thank you so very much' for this additional information and for taking the time to test the installation. Uninstalling PSP, then trying again by running Setup in compatibility mode installed without any of the earlier warnings. It seems to have applied 'Windows XP (Service Pack 2)' which is the same as the compatibility mode for PSP7 on my main machine. After the first run Windows 10's Compatibility Assistant popped up to say it had applied compatibility settings. PSP7 is fully installed and runs (apparently) without issue. The InstallShield threw up a couple of 'unknown source ".' warnings, but clicking on OK let it continue to completion. It was already installed under Windows 7 before I upgraded that to Windows 10.Īs a test, I have just installed it on my test machine (System Two in my specs below).